Protect your fleet! These bow bumpers will protect your bows and your transoms. Remove the crunch from team racing.
Rough up the back side with some 80 grit, clean with acetone. Hold the
bumper on the bow, draw around the edge with a pencil. Masking tape ~3/16"
outside this, wipe the bow with acetone to clean & remove the pencil. Run
the 4200 back and forth and fill the whole backside of the bumper with lines
of adhesive. Press it in place on the boat and push firmly so it oozes out
all around. Make a nice filet with the finger at the edges, remove tape and do a final clean. Apply some tape to hold until the adhesive cures.